LED Chaser using 4017 Counter and 555 Timer

Ligo George

6 years ago

Contents

1 Introduction
2 Components Required
3 Circuit Diagram
4 Working
- 4.1 Tip
5 PCB
6 Video
7 Download Here

Introduction

A simple LED chaser hobby circuit can be made using 555 timer and CD4017 counter IC. You can use this circuit for decorative purposes. By modifying the circuit in a proper way, you can even use this to control lights working on AC mains.

Components Required

CD4017 Counter IC – 1
555 Timer IC – 1
LED – 11
680Ω Resistor – 11
10KΩ Resistor – 1
10KΩ Variable Resistor – 1
10μF Capacitor – 1
0.01μF Capacitor – 1
9V Battery / Power Supply – 1

Circuit Diagram

LED Chaser using 4017 Counter and 555 Timer

You can see that the 555 timer wired as an astable multivibrator and its output is connected to the clock input of 4017 counter IC. The output frequency of the 555 timer is determined by the resistors R1, RV1 and capacitor C1. VCC (8^th pin) and GND (1^st pin) is connected to the power supply. Reset (RST – 4^th pin) is connected directly to the positive power supply to avoid accidental reset of 555 timer. Control Voltage (CV – 5^th pin) is not used, so to avoid high frequency noises we are connecting a capacitor (C2 – 0.01μF) to the ground.

LED D1 is used to indicate the output of 555 IC and the resistor R3 is for current limiting.

Similarly VDD (16^th pin) and VSS (8^th pin) of the CD4017 IC is connected directly to the power supply. Clock enable (13^th pin) is an active low input, so it is connected to ground. Clock input (14^th pin) is connected to the output of 555 timer. Each decoded output pins (Q0 ~ Q9) is connected to LED. Resistor R3 is used for current limiting. Only one resistor is required for limiting current through all LEDs since only one LED will turn on at a time.

Working

You can easily understand the working of the circuit from the above animation. As I explained above, 555 timer is wired as an astable multivibrator. Please read the article Astable Multivibrator using 555 Timer for detailed explanation. So the 555 will produce square wave output and which will act as a clock for the CD4017 counter IC.

You can see that for each high pulse output of 555, the output of 4017 is incrementing by one. Output frequency of 555 astable is given by the following equation.

Output Frequency = 1.44/((R1 + 2RV1) * C1)

So you can easily change the output frequency of above circuit by varying the preset RV1. By this we can change the LED chasing speed.

Tip

You can make use of Reset input (15^th pin – MR) if you want to reduce the number of LEDs. Just connect the output pin to the reset pin as shown below. For eg. if you need only 2 LEDs, you can connect Q2 (4th pin) to Reset pin.