Comments on: EasyEDA vs DipTrace vs OrCad

By: Ligo George

Ligo George — Wed, 19 Sep 2018 23:00:15 +0000

In reply to Pokky.

Yes, that might be correct. You can email me at [email protected]

By: Pokky

Pokky — Tue, 18 Sep 2018 10:12:18 +0000

Try to ask google 😀 … I think, than use only simply OCR, because on the picture is texts “PCB” and “M66”.
Is it possible to share some more detail about schematic and layout of the board? Thank you.

By: Ligo George

Ligo George — Mon, 17 Sep 2018 19:42:51 +0000

In reply to Pokky. OK good. But how google knows this image is of M66, I didn't mention M66 anywhere in the website. Might be coincidence or their AI will be so powerful to match even a footprint in a PCB design :-) .

By: Pokky

Pokky — Mon, 17 Sep 2018 15:44:50 +0000

In reply to Ligo George. Hi, Google found :-) but i dont know how. To query "M66 diptrace" is the first picture. Before, than I found your website I did not know what is diptrace, so I found this picture after few minutes with "M66" and "PCB" queryss.

By: Ligo George

Ligo George — Sun, 16 Sep 2018 12:41:15 +0000

In reply to Pokky. Hi, I created that component in Diptrace. I wonder the way you found the M66 footprint in this article, even though this article was not about M66.

By: Pokky

Pokky — Tue, 04 Sep 2018 09:06:04 +0000

Hi, where you found the image of DipTrace? I want to make my own M66 GSM module and layout in this picture look good.