Arduino

Arduino Microcontroller Development
Board Tutorials.

Tilt Sensor

Interfacing Mercury Tilt Switch with Arduino Uno

In this tutorial we will learn how to interface Tilt Sensor with Arduino Uno. As the name suggests, it is an electronic device used to detect the orientation or tilting of an object and provides digital output based on the orientation. It behaves like a normal ON - OFF switch that is controlled by tilting. Tilt sensor consists of a mercury ball and two contacts in a sealed enclosure, in which the mercury ball will short the leads based on...

May 10, 2020By Arduino, Tutorials, , , 0 CommentsRead more...
L298N Motor Driver Module

Interfacing L298N Motor Driver with Arduino Uno

In this tutorial we will learn how to interface L298N motror driver with Arduino Uno. You might be thinking why we need L298N for controlling a motor. The answer is very simple, Arduino board or a microcontroller IO pins don't have enough current/voltage driving capability to drive a motor. For driving the motor in both directions (clockwise and anti-clockwise) we need to use an H-Bridge. Please read our article H-Bridge - DC Motor Driving for more information. L298N is an...

May 21, 2020By Arduino, Tutorials, , , 0 CommentsRead more...
DHT11 Temperature and Humidity Sensor Module

Interfacing DHT11 Temperature and Humidity Sensor with Arduino Uno

In this tutorial we will learn about Interfacing DHT11 Temperature and Humidity sensor with Arduino Uno. The term DHT is an abbreviation of Digital Humidity and Temperature sensor. DHT11 consists of a resistive humidity sensor, NTC temperature sensor and an 8-bit microcontroller providing cost effectiveness, anti-interference ability, excellent quality and fast response. Components Required DHT11 SensorArduino Uno0.96 inch OLEDBread BoardJumper Wires DHT11 Temperature and Humidity Sensor DHT11 Temperature and Humidity Sensor Module - PIN Diagram Specifications Operating Voltage : 3V ~ 5.5VTemperature range : 0...

May 28, 2020By Arduino, Tutorials, , , , 0 CommentsRead more...
Interfacing HC-05 Bluetooth Module with Arduino Uno - Practical Implementation

Interfacing HC-05 Bluetooth Module with Arduino Uno

In this tutorial, I will explain about Interfacing HC-05 Bluetooth Module with Arduino Uno. HC-05 uses bluetooth classic and can be configured in master or slave modes. It can be interfaced with a microcontroller using UART. Components Required Arduino UnoHC-05 Bluetooth ModuleLEDJumper WiresBread Board Software Required Arduino IDEAndroid App - Arduino Bluetooth Controller HC-05 Bluetooth Module HC-05 Bluetooth Module Operating Voltage : 4 V to 6V (have internal 3.3V regulator).Operating Current : 30mAIntegrated antenna and an edge connector.Range about 10 meters.Configurable in both master and slave modes.Pins...

June 27, 2020By Arduino, Tutorials, , , 2 CommentsRead more...
>