Virtual Ground – Opamp

Virtual Ground – Opamp

What is Virtual Ground ?

As the name indicates it is virtual, not real ground. For some purposes we can consider it as equivalent to ground. In opamps the term virtual ground means that the voltage at that particular node is almost equal to ground voltage (0V). It is not physically connected to ground. This concept is very useful in analysis of opamp circuits and it will make a lot of calculations very simple.

Virtual Ground – Opamp

Lets see how the virtual ground concept is employed in inverting amplier.

Virtual Ground - Inverting Amplifier using Opamp
Virtual Ground – Inverting Amplifier using Opamp

We can explain this concept in two different ways using two different characteristics of an ideal opamp.

Using Infinite Voltage Gain

We already know that an ideal opamp will provide infinite voltage gain. For real opamps also the gain will be very high such that we can consider it as infinite for calculation purposes.


  • Gain = Vo/Vin

As gain is infinite, Vin = 0

  • Vin = V2 – V1

In the above circuit V1 is connected to ground, so V1 = 0. Thus V2 also will be at ground potential.

  • V2 = 0
Virtual Ground - Inverting Amplifier using Opamp
Virtual Ground – Inverting Amplifier using Opamp

Why we need Virtual Ground ?

Virtual Ground concept is very useful in analysis of an opamp when negative feedback is employed. It will simply a lot of calculations and derivations.

Equivalent Circuit - Inverting Amplifier - Virtual Ground - Opamp
Equivalent Circuit – Inverting Amplifier – Virtual Ground – Opamp

Virtual Ground vs Real Ground

Virtual Ground Real Ground
Virtual Ground is a concept that made for easy explantaion and calculation purposes. Real Ground is a terminal which is physically connected to ground or earth which acts as the reference point for the entire circuit.
Voltage is approximately Zero Voltage is Zero
Not able to sink infinite current It is an infinite current sink
Not electrically connected to Ground Electrically connected to Ground

Note

Above concept is valid only when negative feedback is applied to opamp like in inverting ampliers.

Share this post

  • If you hold the non-inverting (+) input of the op-amp at, say, 5 volts, the voltage at your “virtual ground” node will be 5 volts. It is still a “virtual ground” node.
    The point is — a virtual ground node can be at any fixed voltage. It is NOT a requirement that it be near zero volts.

  • Due to this infinite input impedance, current flowing into the terminals will be zero. Thus, as per ohms low the voltage drop across the input impedance will be zero. Thus V2 = 0.

    “I think voltage drop across input impedance is infinite”


  • >